Expert Answers about Winnebago Brave Motorhome

• Where to Connect 3 Wires on Back of 6 Gallon Atwood RV Water Heater
• The 3 wires on the back of the Atwood RV Water Heater # AT96163 you referenced should be attached accordingly: Black - Hot Lead to Switch Green - Ground Lead to Ground White - Common Lead to Element I have attached a clip from the instructions for you to check out. Please note that we recommend that the installation and service must be performed by a qualified installer, service agency, or gas supplier.
  view full answer...


• How To Install Tekonsha Prodigy P2 90885 In 2001 Winnebago Brave Built On Workhorse Chassis
• I would be happy to go over how to install the Tekonsha Prodigy P2 # 90885 you were looking at in your 2001 Winnebago Brave Motorhome built on the Workhorse Chassis, but there is not a plug and play option available for the Workhorse Chassis. Instead you will need to use the Wiring Kit # 5506 and like some extra wire # 10-2-1 due to the length of your RV to get the controller installed. You will need to make the following connections to the controller wiring harness: Red wire to cold...
  view full answer...